Cable for CS9100 Navigation Box Connection to Audiovox Multimedia Systems
Short review. Additional cable for CS9100 navigation box connection to Audiovox (Jensen) multimedia system with touch screen display.
Additional cable for CS9100 navigation box connection to Audiovox (Jensen) multimedia system with touch screen display. It allows you to transmit image (RGB) and sound (mono) from the CS9100 navigation box to AV receiver and control navigation system via touch screen display.
Audiovox Cable for CS9100 Navigation Box
Compatibility
Audiovox (Jensen) Multimedia Receivers
- VM9022 1
- VM9022HD 1
- VM9312HD 2
- VM9212N 2
- VM9213 2
- UV9 2
- VM9223 6
- VM9312HD 2
- VM9313 3
- VM9412 3
- VM9413 4
- VM94234
- VM9512 3
- VM9512HD 3
- AMM10N 3
- AMM12N 3
- VME 9022 TS 1
- VME 9122 TS
- VME 9309 TS 5
- VME 9312 TS 2
- VME 9314 TS 5
- VME 9512 TS
Press and hold the following buttons to switch to CS9100 navigation box mode:
- PIP
- WIDE
- DISP
- NAV
- WIDE/NAV
- PIC
Navigation Boxes
- CS9100
- CS9100 RV
- CS9200
- WP9100R (RV)
- WP9100 Scale
- WP9200
- Element F1
- Element F10
- Element F15
- Phantom SPT-100
- Phantom SPT-200
- NAVIBOX (Outsourcing)
Audiovox Cable for CS9100 Navigation Box
Installation Guide
You need to activate corresponding protocol before CS9100 navigation box connection to Audiovox multimedia system. To do this, power navigation box and connect it to TV set or any other video signal receiver using composite video output. Then configure CS9100 using the remote controller:
