New Accessories for CS9100 Car Navigation Box!
New products have been added to Accessories for Navigation Boxes category:
GPS antenna, remote control, speaker and power cable are included into package of CS9100 navigation box and navigation systems on its base. Now you can buy them separately if one of these devices breaks down or you just want to replace it.
PIC Controller for CS9100 Navigation Box
PIC controller is designed for CS9100 car navigation box firmware upgrade. Now you don't need to send your navigation module to us to have your firmware upgraded if you, for example, are connecting navigation box to new multimedia receiver and it fails to display image from the box or transmit control commands from OEM touch screen to navigation box. You just need to buy and replace PIC controller in your navigation box. With the new PIC controller you will get fresh 47th firmware version with new protocols support and correction of ones already supported by your module. This controller is compatible not only with CS9100 /CS9100RV navigation boxes and navigation systems on their base, but also with WP9100R (RV), Element F1, Phantom SPT-100, WEG-160 modules.
Please note that in order to avoid board damaging PIC controller replacement (dismantling and soldering) shall be done only by qualified specialist!
GPS Antenna for CS9100 Navigation Box
Compact external GPS antenna is designed for operation with CS9100 navigation box, however it fits almost all navigation systems / modules and GPS navigators with SMA connector. Cable length allows you to install antenna in any convenient place in the car or on its body (let's say, on the roof). Due to built-in magnet you will not need any other holders for antenna installation.
Remote Control with Touchpad for CS9100 Navigation Box
Remote control unit with touchpad is designed for convenient operation of car navigation modules. It transmits signals via radio channel and does not need IR receiver.
Please note: you need to pair up remote control and navigation box before starting. Synchronization is also necessary after low batteries replacement, after new remote control purchase, and also if you remove and insert batteries during navigation box operation. This remote control unit is compatible not only with CS9100 /CS9100RV navigation boxes and navigation systems on their base, but also with a number of other navigation modules.
Speaker for CS9100 Car Navigation Box
Mono speaker for CS9100 car navigation box is meant for navigation voice prompts reproduction. Device is connected to preamplified SPK output of navigation module.
Power Cable for CS9100 Navigation Box CS9100
2.5 m long power cable allows connecting navigation box to car on-board power system. Cable is equipped with filter which protects the device from high-frequency noises in electrical network.
Learn more detailed information on the product pages in Accessories for car navigation boxes category, and also have a look at our CS9100 navigation boxes and systems!
