Nissan Altima Sentra Rogue Murano Frontier Titan Reverse Camera Kit With 32 Pin Cable Wire Harness

This kit includes a 170° wide-angle reverse camera, connection cables (6 m / 20 ft), and a 32-pin wire harness that ensures seamless integration into your car`s system. Fits Nissan Altima Sentra Rogue Murano Frontier Titan 2011 2012 2013 2014 2015 2016 2017 2018 2019 MY with Nissan Audio multimedia system.

The device is connected to the 32 pin socket (as shown in the connection diagram below). Depending on your car radio model, this socket may be located in a different place from the one shown in the diagram. After connection all factory devices that work using this socket will not be disturbed and will continue to work as they did prior to the connection.

If your car radio was not installed by the manufacturer, the backup activation signal may be absent from the wires connected to the car radio. For cases like this there’s a gray REV wire in our cable. +12 V should be supplied to this wire when the car is switched to reverse (may be taken from the rear lamp). Also, you may check the connection of this activation signal in the diagnostics menu.

The reverse camera should be powered from ACC line (first turn of the key), otherwise the camera input will be not active. Depending on the type of the camera to be connected, namely on the voltage required for the camera, you can use input voltage +6 V, which the monitor produces. In case the camera requires more than +6 V, connect the camera power to ACC line.

Compatible Models

The photo is provided for reference only. Appearance of the control panel and monitor may slightly differ depending on the car model.

Installation Guide

Package Content

1. Reverse Camera (720P) with 4PIN connector - 1 pc.
2. Wire Harness (32-pin) - 1 pc.
3. Connection Cables (6 m / 20 ft)