Cable for Navigation Box Connection to JVC Multimedia Systems (JVC-TC1)

Additional cable JVC-TC1 for navigation boxand other GPS modules connection to JVC multimedia system with touch screen display. Cable is designed only for control commands transmission from the JVC multimedia receiver touch screen. Image and audio signals are transmitted via RCA cables (not included in the package).
The cable is connected to POSITION OUT connector.

JVC Cable for Navigation Box
Compatibility

JVC Multimedia Receivers *

• KW-AVX626 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX805 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX810 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX815 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX820 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX824 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX825 (A, E, EU, J, U, UI, UN, UT)
• KW-AVX826 (A, E, EU, J, U, UI, UN, UT)

Before purchase check whether they are equipped with Position Out output.

Navigation Boxes

• CS9100
• CS9200
• CS9900
• CS9320
• WP9100R (RV)
• WP9100 Scale
• WP9200
• Element F1
• Element F10
• Element F15
• Phantom SPT-100
• Phantom SPT-200
• NAVIBOX (Outsourcing)

JVC Cable for Navigation Box
Installation Guide

You need to activate corresponding protocol before navigation box connection to JVC multimedia system. To do this, power navigation box and connect it to TV set or any other video signal receiver using composite video output. Then configure box using the remote controller: